Lay-out of fence. See tape on both ends holding table on. Fence has no lock-down or angle lock-down.

More on fence- cross-cut

Paint damage from shipping - just needs paint for touch-up

Bar eroded, also on rail on saw

toggle switch set-up

Joiner shield - chrome badly eroded - looks terrible

First table from X-31 - just a little

Better shot of cross-cut fence

Side view

Front view of paint problems on the end of the main table

Obligatory cat picture - One-eyed Tess

Close-up of end of table - Bad paint

Bad edge of case - plue channel is not cut properly as if the mill missed a beat

More of the same

Look at edge when table moves back and forth

same as previous

Need a set of screws for sharpening plate 5 to level

Left over parts - what are they for?

Very poor weld - Looks like it doesn't match the machine.

Bad weld

Band-Saw handle - extremely terrible quality - what's the problem?

Really, really poor quality!

More parts

Where does this go on the bandsaw?